background image

PDWMU105

Professional UHF Handheld Microphone

Pro Audio Wireless Mic Transmitter System

with Adapter Receiver, Selectable Frequency

www.PyleUSA.com

RECEIVER AND TRANSMITTER INTRODUCTION

HOW TO USE?

1. Turn 

ON/OFF

 switch to 

ON

, the LED indicator is lit. Then insert the 1/4”(6.3mm) Input Jack into audio input    

    socket.

2. Install 

2PCS AA

 batteries in battery compartment. Make sure the polar is correct.

3. Turn 

ON

 the transmitter, the Frequency Display is bright. Then you could use this system.

4. When the receiver is out off battery, please use the rechargeable cable to charge the built-in battery of the    

    receiver.

Notice:

1. If there is any noise, distortion, dead points when using this system, it may be caused by low battery, please   

    replace with new battery.

2. After stop using it, please turn the switch to “

OFF

”.

3. If you don’t use this system for long time, please take out the batteries.

FREQUENCY MATCHING: 

If there are multiple sets of products in the same environment, crosstalk may occur (same frequency and ID). 

It can be completely solved after matching operation according to the following steps.

1. Turn 

OFF

 the transmitter and receiver at the same time.

2. 

Transmitter:

 Press and hold 

ON/OFF

 switch and Frequency Selection Button at the same time for about 4    

    seconds, then the Frequency Display will flash

3. 

Receiver:

 Turn 

ON

 the power switch of the receiver, then the RF LED indicator flashes four times.

4. 

Transmitter: 

Shortly press the Frequency Selectable Button to exit the matching operation.

4

1

2

3

1

2

1. ON/OFF switch
2. Frequency Selection Buttom
3. Frequency Display
4. Battery Compartment

1. ON/OFF sweitch
2. Antenna
3. RF LED indicator
4. DC 5V rechargeable power input

Отзывы: