PCJD50
Hybrid Acoustic/Electronic Cajon
Stringed Cajon with Built-in Pickup Connector,
Internal Guitar Snare Strings
www.PyleUSA.com
1
2
3
4
1.
Nail Socket:
6.35 mono pickup output socket, the socket
with the power switch, the power will be supplied auto
matically when the connector plug is inserted, the power
will automatically power’s OFF when unplugged.
2.
Condenser Pickup Microphone:
The microphone comes
with 3M glue at the bottom, and paste it inside of the drum
(as the installation drawing)
3.
Battery:
9V battery is packed in the built-in strong 3M
rubber battery pack, and paste on the bottom of the drum.
4.
Volume adjustment knob:
Paste on the side of the sound
hole of the drum
Pickup installation steps:
1. The bottom left corner of the back board of the drum has a 12mm hole for nail.
2. Attach the microphone to the back panel of the drum, the distance from the sound hole edge can be adjusted
according to the timbre requirement of each drum.
3. Attach the volume control knob to the back panel of the drum, the knob should be higher than sound hole edge, it's
more convenient for adjusting the volume, clockwise to increase the volume, counter-clockwise to reduce the volume.
4. 9V battery is packed in the battery pack, 3M adhesive Velcro is attached to the bottom of the drum, near the back
panel.
5. Install the tail nail socket on the back board of the drum. (as picture below)
6. Tie the extra thread with a sticky buckle, paste to the back board, avoid noise caused by vibration when playing.
Back side of cajon
Left side of cajon
Condencer Microphone
12mm Nail socket
9V Battery pack
Tapping side of cajon
Volume adjustment knob
Right side of cajon
