7.5 MASTER / SLAVE function
The PX184 module has a built-in DMX-512 receiver and it can be controlled from any desktop
operating in this standard. Additionally, it comes with a programmable response function to no
DMX signal (
noS
). With 18 built-in factory programmes, it is possible to get effects without an
external controller.
In larger installations, several PX184 modules implementing the same programme cannot
provide full synchronization of playback. This is why PX184 has been equipped with the MASTER
function. When the function is enabled, the module changes from the DMX receiver into a signal
transmitter, and sends executed programmes to other modules (which must be set as SLAVE).
With this solution, precise synchronization is possible in even very large installations.
ENTER
ENTER
ENTER
NEXT
NEXT
NEXT
ENTER
ENTER
3x
NEXT
To set the MASTER/SLAVE function do as follows:
1. Go to the
C_d
tab located in the group settings sub-
category and click "enter".
2. In the Con settings set
one
driver as MASTER (select
"
on
")
and the rest as
SLAVE (
oFF
)
Setting the MASTER function will be signalled by rapid
blinking of the LED.
3. In the
CHn
settings, the user specifies the number of
outgoing DMX channels, and this is possible in the
range of 24 - 512.
NOTE
:
PX184 sends three channels (R, G, B) repeated several times on consecutive DMX channels.
13
158
130
23,4
Содержание PX184
Страница 1: ...PX184 R LED Driver 3 x 700mA 48V MANUAL...
