RD100 & RD200 PVA
Revision A (2016)
8 of 35
System Overview
Any uses other than listed could result in a dangerous condition and cannot be
protected against by the safety features installed on the system. The system can have
one or two rotary tables and one or two valves. The system can also have a foot pedal or
finger switch(es). If there is only one rotary table, you will not see options for “R” or “L”
valves and rotary tables on the HMI screens.
Theory of Operation
The RD100 and RD200 have a programmable rotary table that is ideal for dispensing
circular or angled patterns. This simple dispense system uses a stepper motor on the
base to rotate the part simultaneously as the dispense head above accurately applies a
bead of fluid. Flexibility and adjustment of the dispense head, rotation angle, and
programmable control interface allow this simple dispense system to apply seamless
beads of adhesives and sealants.
Operation and Storage Environment
•
Handling and transportation should be done to minimize the vibration and
shock on the system. Use an air-ride truck for transport.
•
The system should be installed and stored on a level surface away from standing
water, possible overspray and overhead leaks.
•
Operate and store the system at 40
°
F - 105
°
F (4
°
C – 41
°
C) and low humidity. Do
not let condensation collect on the system. Cover the system if it will be left for
an extended period of time.
Environmental
Noise Levels
The audible noise level of the machine is below 70 dBA.
Materials/Chemicals
There are no dangerous materials or chemicals used in the operation of the machine.
Refer to the MSDS sheet on the material being dispensed.
