PURSUIT S428 SPORT, Руководство пользователя

Страница: 122 / 196

Seasonal Maintenance
12-2
correct location, the bunks should match
the bottom of the hull and should not be
putting pressure on the lifting strakes.
• Make sure the engines are in the down
position.
• Make sure bunks and rollers are ad-
justed so they are not putting pressure
on the lifting strakes and are providing
enough support for the hull. Hull damage
resulting from improper cradle or trailer
support is not covered by the Pursuit
warranty.
Preparing The Boat For Storage:
• Remove the bilge drain plug(s), if in-
stalled.
• Thoroughly wash the fiberglass exterior,
especially the antifouling portion of the
bottom. Remove as much marine growth
as possible. Lightly wax the exterior
fiberglass components.
• Remove all oxidation from the exterior
hardware and apply a light film of mois -
ture displacing lubricant.
• Remove propellers and grease the
propeller shafts using light waterproof
grease.
• Remove batteries and clean using clear,
clean water. Make sure batteries have
sufficient water and terminals are clean.
Keep the batteries charged and stored in
a cool, dry place and safe from freezing
throughout the storage period.
• Refer to section 4, Electrical Systems,
for information on the maintenance of
the AC and DC electrical systems.
• Coat all faucets and exposed electrical
components in the cabin and cockpit
with a protecting oil.
• Clean, drain and completely dry the fish -
boxes, sinks and livewells.
• Thoroughly clean the interior of the boat;
vacuum all carpets and dry-clean drapes
and upholstery.
• Remove cushions
• Open the refrigerator/cooler door and as
many locker doors as possible. Leaving
as many of these areas open as pos-
sible will improve fresh air ventilation
during the storage period.
• Place a mildew preventive system in the
cabin area before it is closed for storage.
• Clean the exterior upholstery with a good
vinyl cleaner, and dry thoroughly. Spray
the weather covers and boat upholstery
with a spray disinfectant. Enclosed areas
such as the refrigerator, shower basin,
storage locker areas, etc. should also be
sprayed with a disinfectant.
12.2 Winterizing
Fresh Water System
The entire fresh water system must be com-
pletely drained. Disconnect all hoses, check
valves, etc., and blow all the water from the
system. Make sure the water heater and
fresh water tank are completely drained.
Use very low air pressure only when blowing
water from the system to prevent damage to
components. The check valve mechanism
built in the fresh water pump will not remove
the water from the pump. Remove the out-
let hose on the pump, turn it on and allow it
to pump out any remaining water (approxi-
mately a cupful).
An alternate method is to use commercially
available nontoxic, fresh water system anti-
freeze. After draining the potable water tank,
lines and water heater, pour the antifreeze
mixture into the fresh water tank, then prime
and operate the pump until the mixture flows
from all fresh water faucets. Be sure to open
ALL faucets, including the fresh water spray
head in the stern bait station sink and the
water supply valve for the head. Make sure
antifreeze has flowed through all of the fresh
water drains. Allow the antifreeze to fill the
sink traps.
The shower/cabin drain sump system must
be winterized also. Clean debris from the
drain and sump and flush for several minutes