PURSUIT OS 345, Руководство пользователя

Страница: 49 / 144

Plumbing System
5-3
Section 5
OS 385
Operation
Make sure the ball valve is open before
attempting to operate the raw water wash-
down system. The pump is activated by the
washdown switch located on the helm.
When activated, the pressure switch will
automatically control the pump. As pressure
builds in the washdown hose, the pump will
shut off. When the washdown hose is in use
and the pressure drops, the pump will turn
on. Turn the switch off when the washdown
is not in use. The raw water washdown is
equipped with a sea strainer on the intake
side of the pump, located in the aft bilge;
check it frequently and clean as necessary.
Priming the System
Open the ball valve and hose connector, and
activate the pressure pump. Run the pump
until all air is purged from the system. Close
the thru-hull ball valve before the boat is
hauled from the water to eliminate an air
lock in the system. It may be necessary to
re-prime the raw water system if the system
is not used for an extended period.
5.3 Livewell
Seawater is provided to the livewell by a 12-
volt circulating pump. This pump is designed
to carry a constant flow of water to the
livewell. The pump is activated by the
livewell switch on the helm. An overflow built
into the livewell automatically controls
livewell water level. Always turn livewell
pump off at the switch panel when not in
use.
To fill livewell, plug drain fitting at the bottom
of the livewell. Make sure the ball valve at
the intake thru-hull fitting is open and turn on
livewell pump. When water level reaches the
overflow, it will begin to circulate.
To drain, turn off pump and remove plug.
When the livewell has drained, use the
washdown hose to flush livewell and drain
debris.
Close the livewell thru-hull ball valve when-
ever livewell is not in use to prevent water
from entering the livewell while the boat is
cruising. The livewell pump is equipped with
a sea strainer on the intake side of the pump
located in the aft bilge. Check it frequently
and clean as necessary.
Do not use livewell for stowage. Seawater
can enter livewell when it is not in use and
damage stowed equipment.
5.4 Drainage
General
Some drain thru-hull fittings are equipped
with ball valves that are always open under
normal operating conditions. In the event of
an emergency, close the valves to prevent
sea water from entering the boat through the
drainage system. Check and operate the
drain valves at least once a month to make
sure they are in good condition and operat-
ing properly. Also, check the drain system to
ensure it is free flowing and hoses on the
thru-hull fittings are secure and not leaking.
!
CAUTION
DO NOT operate high-pressure pump
dry, damage to pump will result. Turn
the raw water pump switch "OFF"
when leaving the boat unattended.
Washdown Hose Connector