PURSUIT OS 345, Руководство пользователя

Страница: 20 / 144

1-4
Section 1 Propulsion Systems
OS 385
Voltmeter
The voltmeter displays the voltage for the
battery and the charging system. The nor-
mal voltage for a full charged battery is 12.6
volts with the engine(s) off and 13 to 14.5
volts with the engine(s) running.
Hourmeter
The hourmeter keeps a running total of
engine hours while operating.
Tilt/Trim Gauge
The tilt/trim gauge monitors the position of
the outboard engine. The upper range of the
gauge indicates the tilt, which is used for
shallow water operation, trailering and to
keep the gear case out of the water. The
lower range indicates the trim position. Trim
is used to adjust the hull angle while operat-
ing your boat on plane. Refer to the engine
owner’s manual for more information on the
operation of the outboard power tilt and trim.
Engine Alarms
Most outboards are equipped with an audi-
ble alarm system mounted in the helm area
to monitor selected critical engine systems
and functions. The alarm will sound if one of
these systems begins to fail. Refer to the
engine owner’s manual for information on
the alarms installed with your engines.
Fuel Management
Fuel management systems are standard
equipment with some outboard engines. On
Yamaha® engines, the fuel management
gauge is a multifunction gauge used to mon-
itor fuel consumption of the engines. If your
boat is equipped with this system, refer to
the engine or fuel management manual.
Instrument Maintenance
Electrical system, instruments and ignition
circuitry are protected by a circuit breaker or
fuse located on the engine. The ignition
switches and all instruments, controls, etc.
must be protected from the weather when
not in use. Excessive exposure can lead to
gauge and ignition switch failures.
Moisture may fog the inside of the gauge
lens. Turning the gauge lights on will help
dry the lenses. Fogging will normally not
harm the gauges, but if the fogging contin-
ues and moisture accumulates, the excess
water can damage the gauges. The gauges
are designed with drain holes to reduce the
accumulation of moisture. Make sure that if
a gauge is removed, it is reinstalled with the
drain holes in the proper position.
!
CAUTION
If an engine alarm sounds, shut off the
engine, investigate the problem and
correct it.