PURSUIT 2870 OFFSHORE, Руководство пользователя

Страница: 40 / 132

2870 OFFSHORE
40
DISCONNECTING PROCEDURE FOR SHORE POWER CONNECTION
Turn the main breaker on the AC panel and the disconnect switch on the dockside outlet to the “OFF” positions.
Disconnect the cable from the dockside outlet and replace the outlet caps. Disconnect the cable from the boat
and close the inlet cap. Store cable.
AC BREAKER PANEL
The AC panel is located in the cabin. The following are descriptions of the AC panel equipment and the
breakers that protect the accessories:
AC Amp Meter
Indicates the total amperage or current being drawn through the AC panel.
AC Volt Meter
Indicates the voltage supplied to the panel.
Galvanic Isolator Monitor
The monitor for the galvanic isolator is mounted in the AC breaker panel. The monitor continuously tests
and displays the condition of polarity, ground wire continuity and galvanic isolator functioning. Refer to the
galvanic isolator monitor owner's manual.
Reverse Polarity Light
The red light indicates reverse polarity current supplied to the panel. This situation will cause the red light
to remain lit. Additionally, a special relay attached to the main breaker will automatically turn the main
breaker off whenever reverse polarity is achieved. If reverse polarity is achieved, immediately turn off all
cabin AC breakers and dockside outlet breakers. Disconnect the power cable from the dockside outlet and
notify a qualified electrician to check the dockside wiring.
AC Main Breaker
Protects the general distribution network. This breaker is very sensitive. The resulting power surge that occurs
when connecting the dockside cord may cause the main breaker to trip. To avoid this surge, always turn the
main breaker to the “OFF” position before plugging or unplugging the shore power cord. The AC
panel also is equipped with a relay that will cause the main breaker to trip when reverse polarity current is
detected.
Microwave
Supplies AC current directly to the microwave oven. See the microwave manual for more information.
Air Conditioner (Optional)
Supplies electrical current to the air conditioning control panel and the air conditioner raw water pump when
this option is installed. Otherwise it is reserved for additional AC equipment. This breaker will trip if sea
water is not being supplied to the air conditioning unit. If this breaker trips, reset and check for water flow
out of the air conditioning thru-hull. Refer to the air conditioner owner’s manual for additional information.
Outlets
Supply electrical current to the cabin ground fault interrupter (GFI) electrical outlets. All AC electrical outlets
are provided with ground fault interrupters to protect against electric shock. These outlets should be tested
periodically to ensure proper operation by pressing the test/reset buttons in the center of face plate. GFI outlets
do not protect against short circuits and overloads. This is done by the outlet breakers on the AC panel.