User Manual
PT-PSW-41RS
10
Signal removing
Once removing the current display signal, the Scaler Switcher will detect all input
signals with priority from HDMI to VGA. When detected the first signal, it will
transfer to output.
Notice
:
In manual-switching mode, if you set the signal format of VGA/DVI input to
C-video or YPbPr, the system will not be able to enter Auto-switching mode.
In auto-switching mode, if the signal format of DVI input is C-video/YPbPr, the
Scaler Switcher can’t detect the DVI input, the command 50686% should be sent
via PC to convert C-video/YPbPr into digital signal format, and then the Scaler
Switcher will enter
In auto-switching mode, select input source via front panel button is not
available, but RS232 command and IR remote are able to switch mode.
4.2
IR Control
4.2.1
Control the Scaler Switcher
Firstly, connect IR Receiver to IR IN port;
Secondly, send command
50782%
(IR Mode 2, factory default) via RS232
communication software, the Scaler Switcher can be controlled by using IR remote.
Here is the brief introduction for IR remote of this Scaler Switcher.
