16
Installation & Operation Manual
Copyright © Puretec Pty Ltd 2021
Gas Replacement - As Required
1. Isolate the CO
2
by turning the black knob fully counter-clockwise (-) until home.
2. Unscrew the depleted CO
2
bottle from the regulator. (Turn the empty Co
2
bottle
clockwise).
Note:
Some CO
2
will escape as the valve in the bottle is depressed.
3. Connect the new CO
2
bottle to the regulator by screwing the bottle counter-clockwise
onto the regulator firmly, but taking caution not to overtighten as this may cause the
sealing rubber to perish and leak.
Note:
Use soapy water on the connection between the bottle and regulator to test for
leaks.
Note:
Some CO
2
will escape as the valve in the bottle is depressed.
4. Slowly open the CO
2
regulator by turning the black knob clo) until the gauge
reads 3 Bar.
5. Operate the sparkling button
on the tap for 10 - 15 seconds and allow the tank
to refill for approximately 1 minute, repeating this process until water carbonation is
noticed in the dispensed water.
Note:
The Bar pressure on the CO
2
gauge will fluctuate between 3-4 Bar during this
process and normal operation.
6. Allow 1-2 hours for the water to both chill and reach full carbonation.
Note
: A small amount of water will come out after using the sparkling feature for 1-2
seconds. This is normal as the CO
2
is purged from the line.
7. Check with your local governing bodies for any disposal requirements and discard the
empty bottle.
Gas Replacement