Installation Instructions for
TruLine 1.6A In and Out Connector to Nova
Modular Ceiling or Suspension
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
- This instruction must be used concurrently with TruLine 1.6A
and Nova Modular Suspension or Ceiling installation
instructions.
IMPORTANT INFORMATION
Install the Connector
1:
Determine the location of the In and Out connector on the
TruLine 1.6A channel. Cut out the section of the TruLine
1.6A lens where the connector is going to be installed.
NOTE:
Before installing the connector, make sure the TruLine
1.6A is pre-installed.
1718 W. Fullerton Chicago, IL 60614
Ph: 773.770.1195 ● Fax: 773.935.5613
www.PureEdgeLighting.com ● [email protected]
© 2016 PureEdge Lighting. All Rights Reserved.
Doc # 904-TL1.6A-IO-NOV-CA_02
1
A
TRULINE
CHANNEL
Lens
1
NOTE:
Follow steps described in the TruLine 1.6A installation
instructions to complete the TruLine installation.
B
MOUNTING
PLATE
#2-56
SET SCREW
IN AND OUT
CONNECTOR
PHILLIPS
SCREW
TRULINE
CHANNEL
3
4
2
2:
Loosen
(Do Not Remove)
the two #2-56 set screws with a
0.035" Allen wrench.
3:
Slide out the mounting plate from the connector and place
onto the channel.
4:
Tighten the two screws on the mounting plate so that the
rectangular nuts grab the back of the channel lip securing
the mounting plate in place.
#2-56
SET SCREW
IN AND OUT
CONNECTOR
5
C
5:
Place the connector on the mounting plate and secure it in
place by tightening the two #2-56 set screws with a 0.035
Allen wrench.
0.035"
ALLEN
WRENCH
0.035"
ALLEN
WRENCH
