Pulsar Zenith 140, Инструкция по эксплуатации

Страница: 89 / 161

PULSAR MEASUREMENT
89
The third parameter has no function when miscellaneous relay is chosen
and will not be displayed.
The
fourth parameter , and fifth parameter , are set to determine the switch
points, “ ON ” and “ OFF ” for the relay. See miscellaneous function table
( P211, 221, 231, 241, 251, 261 ) for further information.
P211, 221, 231, 241, 251, 261 = 1 (Clock)
P213, 223, 233, 243, 253, 263 – Relay Setpoint 1
Relay Setpoints are entered in Hours & Minutes (HH:MM) to set Time at
which relay will energise. Default =
00:00 ( HH:MM )
P214, 224, 234, 244, 254, 264 – Relay Setpoint 2
Relay Setpoints are entered in seconds to set the Time Period that the relay
will remain ‘ON’. Default = 0.00 mins.
P210, 220, 230= 2 (Totaliser)
P213, 223, 233, 243, 253, 263 – Relay Setpoint 1
Relay Setpoints are entered as a factor by which the on-board totaliser
(P820) should be multiplied by to provide a relay closure.
Default = 0.00
P214, 224, 234, 244, 254, 264 – Relay Setpoint 2
Relay Setpoints are entered in seconds to set the Time Period that the relay
will remain ‘ON’. Default = 0.00 secs.
Pump by Time
When a relay is assigned to Pump by Time the pump will come on (energise)
at its normal “ ON” level setpoint, and de-energise at its OFF level setpoint
or after a predetermined time period, whichever occurs first.
P210, 220, 230, 240, 250, 260 = 5 (Pump by Time)
When a relay is being used for a pump by time function, the second
parameter determines the pump duty that will be used to determine the
operating cycle.