Pulsar UltraTWIN, Инструкция по эксплуатации

Страница: 153 / 214

PULSAR MEASUREMENT
153
Data Log parameters
P1 and P2 : The data log parameters contain the following information:
Totaliser Audits
P*460 to P*479 Total Audits
When Pump Volume is enabled, parameters P*460 - P*479 show the date
and pumped volume total for the last ten days , the first on the list are the
most recent and last ones are the oldest. When all ten total audits are full
the oldest is pushed out and all totals increment through to allow the new
days total to be registered in the first
day’s total audit parameter allocation.
P*480 Clear Logs
This parameter enables all the Total Audits (P*460 – P*479) to be cleared to
factory default values.
Temperature
The following parameters give information on temperature conditions seen
by the
Temperature source ( P*852 ) in ºC. All these parameters are read
only and cannot be changed, though if P*852 is changed they will be reset.
P*580 Minimum Temperature
This parameter displays the minimum temperature recorded.
P*581 Minimum Temperature Date
This parameter displays the date when the minimum temperature was
recorded.
Important Notice
To ensure the accuracy of Flow during a 24-hour period, ensure that the
Time *P932 is set correctly. And if required, enable Daylight Saving for
the appropriate time difference P*970 – P*979 .
Important Notice
In the following parameters, * denotes the point of measurement being
used (* = parameter selectable in Point 1 and/or in Point 2).
All menu options are the same for Point 1 and Point 2. Measurement points
can be “toggled” by pressing to change from point 1 to point 2 to
access parameters on each point.