www.pulsar.pl
PSBEN10A12E/LCD
BLACK POWER
44
10. Technical inspections and maintenance.
Technical inspections and maintenance can be performed after disconnecting the power supply from the
power network. The PSU does not require any specific maintenance; however, its interior should be cleaned with
compressed air if it is used in dusty conditions. In case of fuse replacement, use only compatible replacement
parts.
Technical inspections should be carried out not less frequently than once per year. During the inspection,
check the batteries and run the battery test.
4 weeks after installation, re-tighten all screw connections, see Fig. 2 [9].
10.1 Battery replacement of the LCD panel.
Estimated operating time of battery type CR2032 is about six years. After this period, the battery will need
to be replaced.
Battery replacement of the LCD panel should be done during mains operation or battery-assisted operation
in order to avoid resetting the time settings.
CAUTION!
Removed batteries should be stored in a designated collection point. Do not reverse the
polarity of the batteries. Do not use batteries of different types. Improper use of the battery
may lead to explosion.
WEEE LABEL
According to the European Union WEEE Directive, waste electrical and electronic equipment should
be disposed of separately from normal household waste. Waste electrical and electronic equipment
must not be disposed of with normal household waste.
CAUTION!
The power supply unit is adapted for cooperation with the sealed lead-acid batteries (SLA). After the operation
period they must not be thrown but recycled according to the applicable law
Pulsar sp.j.
Siedlec 150, 32-
744 Łapczyca, Poland
Phone (+48) 14-610-19-40, Fax (+48) 14-610-19-50
E-mail: