Pulsar MICROFLOW, Инструкция по эксплуатации, Страница: 14 / 65

Page
8
Location
When choosing a location to mount the bracket and MicroFlow , note the
following:
•
For optimum readings, it is recommended that the MicroFlow should be
positioned at a 45° angle to the surface of the material being measured.
•
The mounting surface must be vibration-free.
•
The ambient temperature should be between -20ºC and 60ºC.
•
Ensure that the Pulsar Controller is installed in a “Safe”, non-hazardous, area.
Mounting
For the best results, it is highly recommended to use the MicroFlow angled
bracket, which is available from your Pulsar distributor, which will ensure that the
MicroFlow can be correctly installed. The bracket can be used if the MicroFlow
sensor is to be mounted on its own in a specific location or along with a Pulsar dB
transducer. Please see ‘
Angled Mounting Bracket
’ for dimensions of this
bracket, please note that the drawing is not to scale.
‘
Mounting sensor to a bracket
’ illustrates how you would install the sensor to
one of Pulsar’s angled brackets.
The MicroFlow angled bracket should be mounted by marking and drilling the
holes suitable for fixing your screws/bolts (length to suit your application) and
then fixing the bracket in place.
Important Information
When installing the MicroFlow it is recommended that it is mounted at
least 1m away from moving persons or machinery.
All electronic products are susceptible to electrostatic shock,
so follow proper grounding procedures during installation.