Pulsar MicroFlow-i, Инструкция по эксплуатации

Страница: 38 / 56

Page
32
If the sensor fails to connect to the software, please check that the Comport has
been correctly set (details of how to do this is outlined in this chapter). After
launching the program and connecting to the
MicroFlow-i
, the device’s
parameters will be automatically extracted once a connection is established.
Once connected you can now view the information received from the sensor on
the Software’s individual tabs:
Flow , Configuration and Trace .
appears after a connection is established, selecting this will then
disconnect the MicroFlow-i .
Flow Tab
The above picture is an example of the default screen of MicroFlow-i HART PC ,
which is the Flow tab. The dial on the left displays the linear flow velocity of a
maximum up to 6m/s (19.7 ft/s). While the numerical display on the right shows
the velocity flow rate and the current mA reading.
Signal Strength
The signal strength gives an indication of the actual strength of the velocity signal
detected. A level of higher than 70% is desired for reliable operation.