Pulsar MicroFlow-i, Инструкция по эксплуатации

Страница: 36 / 56

Page
30
Connecting to MicroFlow-i HART PC
When connecting to the software using the HART modem, power to the sensor
can be obtained from a 10-28VDC source.
To enable the
MicroFlow-i to work correctly please ensure that the sensor is wired
as shown in the picture below:
To enable the sensor to work correctly, the power (red) cables from the supply and
to the
MicroFlow-i must be wired in series with the 250 Ohm resistor (as seen in
the above picture).
Once the sensor is connected to the HART modem, insert the USB into the
PC/laptop ready for use. You can now use
MicroFlow-i HART PC to change
settings of the sensor to suit your application.
To make a connection to the MicroFlow-i sensor, supply power to the sensor and
then select the button which will change to ‘Scanning’ and
the following pop-up windows will appear during an initial connection:
Important Information
Ensure that power to the sensor is switched ‘OFF’ before removing
cables and any connection is made.
Power (+) to MicroFlow-i
(Red cable)
0V to MicroFlow-I (Black cable)
Power (+) from supply
(Red cable)
0V from supply
(Black cable)
250 Ohm resistor
Connector
from
Connector
from