Pulsar MicroFlow-i, Инструкция по эксплуатации

Страница: 35 / 56

Page 29
Chapter 5 MicroFlow-i HART PC
The software that accompanies the MicroFlow-i can be used to access and change
all parameters via the HART modem, test, obtain and record trace readings from
a sensor. To utilise the features of the software, a USB HART modem which is
available from Pulsar (as shown in Fig.9 below), is required to communicate
between the sensor and your machine.
Software installation
Insert the CD that accompanies the MicroFlow-i sensor into your PC/Laptop. If
you do not have a CD drive on your laptop, then this software can be downloaded
from
the Pulsar Process Measurement website: www.pulsar-
pm.com/support/downloads/software.aspx and choose to download MicroFlow-i
HART PC from the list which will then be downloaded onto your machine.
When setting up the HART modem for the first use, you will need to install the
necessary drivers for it to operate correctly with your OS. These drivers can be
installed from your installation disc. Run the
MicroFlow-i HART PC Setup.exe
from the CD, or from the downloaded file from our website to install the
MicroFlow-i HART PC software correctly, which will automatically install the
necessary drivers for your HART modem. Once downloaded, a shortcut icon will
be created onto your Desktop for ease of use. Double click on this icon to launch
the program.
Important Information
For optimum installation insert your HART modem to your PC whilst
installing
MicroFlow-i HART PC , where your PC should then assign
the modem to a Com Port. Or if you have an internet connection,
upon inserting the USB of the HART modem for the first time,
Windows updates should install this onto your computer for you.
Once the driver’s installation has completed, remove the HART
modem from your machine. Your modem is ready to be used when
a connection to
MicroFlow-i PC is required.
Fig.9