Pulsar Flow Monitor, Инструкция по эксплуатации, Страница: 25 / 61

Page 19
Using the RS232 Serial Interface
The RS232 serial interface is used to program the Flow Monitor and obtain
information using a PC or other computer equipment. To do so, the settings
for control are as follows:
baud rate 19200 , 8 data bits , no parity , 1 stop .
The device should be connected to the RS232 Interface via the RJ11
connector as shown in
Chapter 2 Installation .
Parameter Defaults
Factory Defaults
Factory Defaults
When first installing the Flow Monitor , or subsequently moving or using
the unit on a new application, before proceeding to program the unit for its
intended application it is recommended that you ensure that all parameters
are at their default values by completing a
Factory Defaults P930, as
described in Chapter 5 Parameter Guide .
The date (P931) and time (P932) in the Flow Monitor were set at the
factory, but may need checking or amending if, for example the application
is in a time zone other than GMT, see Chapter 5
Parameter Guide for full
details.
Once you are satisfied with the installation, you can proceed with
programming for the intended application. It is sensible to program all of the
required parameters at the same time. The system will be then set-up.