www.pulsar.pl EN54C-LCD
RED POWER plus
21
7.2.
First run of PSU
– language selection screen.
During first run of PSU, language selection screen will be displayed.
Use „<” or „>” buttons to select available languages.
Fig. 15. Language selection screen.
After selecting appropriate language, confirm by pressing
„SET" button. Main screen will be displayed..
If language selection is not done, language selection screen will be displayed on next startup. If choice has
already been made, language selection can be done as explained in section 8.3.1.
To facilitate the user’s selection of the language of messages, the PSU enables calling up
a menu on the main screen, displaying all available languages. To this end, press the arrow keys
„<” and „>” on the front panel of the PSU simultaneously and hold them for a minimum of 5 seconds.
7.3.
Main screen of LCD.
Main screen of LCD displays basic electrical parameters and indicates current status of power supply
.
Fig. 16. Main screen of LCD.
The resolution of voltage and current measurement is 0.1 V and 0.1 A, respectively.
The displayed values of voltages and currents should be treated with caution; if a greater accuracy is
required, use a multimeter.
Table 5. Description of main screen symbols.
Screen field
Operating status
Failure status
Ndicating presence of upply of 230 V
Blinking
„AC” symbol
Information on the current voltage on the
AUX1 and AUX2 outputs.
Parameter, which value has been
exceeded, is blinking
Information about current state of battery
charge
The battery pictogram is flashing
The value within the symbol indicates the
maximum capacity of the PSU
Blinking warning symbol is displayed
Signal of the status of fuses
Fuse icon
– blinking
Clock