Pulsar dBi-M, Инструкция по эксплуатации

Страница: 21 / 71

PULSAR MEASUREMENT
21
dBi-M
CHAPTER 4 DBI-M PC SOFTWARE
The free dBi-M PC Software is a powerful tool that can be used to aid you in
getting the most from your dBi-M Series Intelligent Transducer.
It can be used to record all the Parameters for your applications, which can
be saved to a PC or USB and stored for future reference. All parameters can
be changed and downloaded to an instrument via your laptop. Remember it
is most important to note that Parameters downloaded to an instrument
must be extracted from the same firmware version as the system to which
they are downloading otherwise errors due to incompatibility may occur.
The PC software can also be used to record and view Echo Profiles from your
applications, these can be saved for your records or sent via e-mail back to
Pulsar Measurement for our engineers to analyse. dBi-M PC software can
also be used to re-program your unit to the latest version of firmware, with
any enhancements that it may contain. Please consult Pulsar Measurement
for further information on re-programming if it is required.
dBi-M RS485 Connector
To connect to the dBi-M intelligent transducer to the free dBi-M PC
Software, you will need to use Pulsar’s RS485 Connector and wire the
transducer to the connecting terminals as shown below:
Wiring Detail
The label on the RS485 connector depicts the order the dBi-M cables are
connected to the connector. The table below also assists to show which
cables are connected to which terminal.
COLOUR DBI-M RS485 CONNECTOR TERMINAL
Orange RS485 + A
White RS485 – B
Green Cable Screen SCN/GND
Black 0V DC 0V/GND
Red Power +5V
A
B
GND
GND
+5V
PC
RS485
USB