Pulsar Measurement FlowCERT, Инструкция по эксплуатации

Страница: 27 / 143

PULSAR MEASUREMENT
27
Voltage Selector and Fuse Location
The voltage selector switch, and mains fuse is located inside the terminal
compartment. This is left of the mains terminals, as illustrated below:
D ON’ T FORGET
Make sure you move the voltage selector switch to the correct position for your
power supply.
Important Information
Before applying AC power (mains), make sure the supply is 115V AC.
Never operate the FlowCERT Lite with terminal access exposed.
An external switch or circuit breaker should be installed near to the
FlowCERT Lite to allow the supply to be removed during installation and
maintenance. In addition, the relay contacts should also have a means of
isolating them from the FlowCERT Lite.
Interconnecting cables must be adequately insulated in accordance with
local regulations. Strip back 30 mm of the outer insulation of the cable.
Strip 5 mm of insulation from the end of each conductor. Twist all
exposed strands of the conductor together. Insert the stripped conductor
into the terminal block as far as it will go and tighten the terminal block
screw. Ensure that all strands are firmly clamped in the terminal block and
that there is no excess bare conductor showing, and no stray strands.
Important Information
If the equipment is installed or used in a manner not specified in this
manual, then the protection provided by the equipment may be impaired.