4K HDBaseT 4x4 Matrix Switcher
PTN Electronics Limited
1
u
r
.
x
o
b
-
v
a
.
w
w
w
7
Here we take the software
CommWatch.exe
as example. The icon is showed as below:
The interface of the control software is showed as below:
Please set the parameters of COM number, baud rate, data bit, stop bit and the parity bit
correctly, only then will you be able to send command in Command Sending Area.
4.3.6 RS232 Communication Commands
Note
:
1)
Please disconnect all the twisted pairs before sending command EDIDUpgrade[X].
2)
In above commands, “[”and “]” are symbols for easy reading and do not need to be
typed in actual operation.
3)
Please remember to end the commands with the ending symbols “.” and “;”.
4)
Type the command carefully, it is case-sensitive.
Parameter Configuration area
Monitoring area, indicates
whether the command
sent works.
Command Sending area
Parameter Configuration area
Monitoring area, indicates
whether the command
sent works.
Command Sending area