PTI security systems Wireless Door Alarm System, Инструкция по установке и эксплуатации

Страница: 60 / 84

Wireless Door Alarm System
55 114A3873.D rev. 7-2017
Installing the Repeaters
1
Determine the repeater location and mount the weatherproof
housing.
2
Mount the repeater in the housing vertically so that the
antennae are oriented as shown in “Drawing 18: Repeater
wiring” on page 53 and the cable opening faces downwards.
3 Use a small screwdriver to press the housing release tab on
the top or bottom of the repeater to separate the housing.
4 Connect the internal battery from the backup battery into the
battery connector as shown in Drawing 18
5 Connect the external power supply at the point shown in
Drawing 18 using 20 AWG or larger wire. Route the cable from
the transformer to unit through the left side of the repeater or
through the oval knock-out section in the rear.
6 The repeater is shipped with a low voltage wall transformer.
This transformer must be plugged into an unswitched 120
VAC outlet. The transformer must be secured to the outlet
using the tab on the transformer, this prevents it from being
accidentally unplugged.
7
The transformer must be connected to the repeater using
20 AWG or larger wire. The length of the wire from the
transformer to the repeater should not exceed 325 feet.