7
PRO STUDIO FLASH KIT
Setting up your studio flash kit
To set up your studio flash kit:
1
Loosen the slider locking knob, pull open the legs on a light stand, then slide the legs down until they are fully
extended. Tighten the slider locking knob to lock the legs place.
2
Open the locking knobs on the center stand column, extend the column to the height you want, then tighten
the knobs to lock the column in place.
Caution:
Make sure the stand’s legs are fully extended and the center column is locked into place before
attaching the flash head.
3
On the flash head, slide the lamp cover release pin, then turn the cover counter-clockwise about 10° to align the
tabs on the cover with the openings on the flash head. Pull off the cover.
Note
To protect the lamp tube when you are not using it or
when your are storing it, replace the cover.
Stand leg
Locking knobs
Center column
Slider locking knob