Psion VH10, Руководство пользователя, Страница: 56 / 166

Chapter 4: Configuration
Bluetooth Quick-Pairing
Psion VH10 Vehicle-Mount Computer User Manual
48
4.4.6 Bluetooth Quick-Pairing
If you are using the Motorola DS3578 or LS3578 Bluetooth scanner, you can pair it with the VH10 quickly
using the barcode label that is affixed above the VH10 keyboard on the right.
First-time Pairing
1. For the first time only, before you can use the quick-pairing feature, you must configure the scanner to
be a
Bluetooth Serial Master Device by scanning the barcode below.
2. Next, configure your VH10 to be discoverable and to offer the scanner Bluetooth service.
i. Go to Control Panel > Bluetooth .
ii. Open the Mode tab (see page 47) and enable both Turn on Bluetooth and Discoverable .
iii. Open the Servers tab (see page 46) and enable Scanner .
3. Scan the PAIR barcode label on the upper right side of the VH10 keyboard. The scanner will beep
to indicate that it is successfully connected to the VH10.
4. Verify that the scanner is operating properly.
5. To disconnect your scanner from the VH10, scan the UNPAIR barcode label on the upper left side
of the VH10.
Subsequent Pairings
1. Scan the PAIR barcode label on the upper right side of the VH10 keyboard. The scanner will beep to
indicate that it is successfully connected to the VH10.
2. Verify that the scanner is operating properly.
3. To disconnect your scanner from the VH10, scan the UNPAIR barcode label on the upper left side
of the VH10.
4.4.7 The Bluetooth GPRS WAN Connection
The following steps describe how to set up an Internet data connection using a GSM cellular telephone with
Bluetooth . The VH10 communicates via Bluetooth to the cell phone, which then accesses a WAN (Wide Area
Network) and transfers data using GPRS.
1. Enable the Dial-Up Networking service in the cell phone.
2. Make the phone discoverable .
3. Pair the phone service with the VH10 Dial-Up Networking service using the Bluetooth Manager .
(For instructions on pairing devices, refer to “Pairing a Device” on page 44.)
4. To set up the Internet parameters, go to Control Panel>Network And Dial-up Connections .
PAIR
UNPAIR
barcode label
barcode label
Note: If the scanner is out of range of the VH10, it may drop the connection. To pair the scanner again,
scan the PAIR barcode on the front of the VH10.