PSG MAX CADDY PF01102, Инструкция по установке и эксплуатации

Страница: 63 / 79

63
28. LINK BOARD OPTIONS CONNECTIONS
28.1. ELECTRICAL CONSUMPTION
Your Max Caddy furnace is able to supply electrical 24V current to control various options. The options that can be
supported are described in the table below. The maximum available 24V current is 1.66 amps (transformer 24V @
40VA). The table below shows the approximate electrical consumption of each of the options that can be installed with
your Max Caddy furnace. It is important to note that those consumptions were determined according to the maximum
consumption of the options tested by the manufacturer. It is possible to find on the market options having higher or
lower electrical consumption than those shown in the table below. In the event that the combined electrical
consumption of the installed options is higher than 1.66 amps, contact our technical support for further information.
WARNING: INCORRECT WIRING CAN DAMAGE THE LINK BOARD.
Option Approximate consumption (mA)
Additional 24V equipment 500
Air conditioning damper 500
Humidifier 500
Heat pump Current supply via additional transformer (not provided)
Thermostat (if not battery powered) 500
* It is important that the sum of the electrical consumption of the installed options is not higher than 1.66 amps.
28.2. OUTDOOR PROBE
* The outdoor probe act as a switch therefore it does not consumes electrical current.
28.3. HOT WATER