PSC PowerWedge 10, Руководство пользователя

Страница: 20 / 116

Programming the PowerWedge 10
15
PowerWedge
®
10
3. Save the setup by scanning the bar code labeled
E
below (or on the
bottom of the PowerWedge 10) twice . After the first scan, the
decoder should beep once and the red LED should flash. After the
second scan, the decoder should beep five times and the green LED
should be lit.
Menu Programming
This programming method makes use of a “menu” of bar codes found on
the bottom of the PowerWedge 10. You can use these bar codes to enter
the programming I.D. numbers and settings listed in
Programming Options on
page 34
.
To program the PowerWedge 10 using the bar code menu . . .
1. Scan the
START
bar code on the bottom of the PowerWedge 10.
NOTE
To quit Auto-Learn mode without saving the setup, scan the following bar
codes (E first, F second):
*E*
*F*
E
*E*
Scan this twice.
NOTE
If you make a mistake or “get lost” while in programming mode, scan the
ESC
bar code. This will reset the decoder to expect a code I.D. number, ignoring
any entries you made since you were last at the base level of programming
mode. To quit programming mode without saving any changes, scan the
E
bar
code and then the
F
bar code.