PSC Mini PowerWedge, Руководство пользователя

Страница: 16 / 72

12
Mini PowerWedge
®
Batch Programming
Batch programming uses bar codes that program the Mini Power-
Wedge with a single scan. Each batch bar code contains commands to
place the decoder into programming mode, set one or more parame-
ters, save the settings, and exit programming mode. When you suc-
cessfully scan a batch bar code, your decoder programs itself to your
settings, beeps five times, and automatically returns to read mode,
ready to go to work.
*$+$-051EE*
Using Provided Bar Codes
The section of this manual titled, “Bar Codes for Programming the
Mini PowerWedge” provides bar codes that you can use for setting
many programming parameters for the Mini PowerWedge.
To use the provided bar codes to program the Mini PowerWedge . . .
1. Use the contents list on page 21 to find the bar codes for the
parameter you are looking for.
2. Use a scanner attached to the Mini PowerWedge to read the bar
code for the setting you want.
NOTE
To accept batch programming, the Mini Power-
Wedge must be programmed to use the extended (or
full ASCII) Code 39 character set. The decoder was
shipped from the factory ready to read the extended
character set. If you have changed the default, scan
the following bar code to enable full ASCII mode:
NOTE
If the parameter setting you want is not included in
this manual, you can create your own bar codes
(see pages 13–14) or use the bar code menu to pro-
gram the Mini PowerWedge (see “Menu Program-
ming,” beginning on page 14).