U
NIVERSAL
W
EDGE
I
NTERFACE
P
ROGRAMMING
For your convenience, this guide provides minimal configuration and op-
tion settings for your scanner's Universal Wedge interface. For more de-
tailed programming information and features, reference the QuickScan
6000/6000 Plus Universal Wedge Programming Guide (R44-1548), avail-
able from your dealer.
D
ISCONNECTING
/C
ONNECTING
THE
I
NTERFACE
(I/F) C
ABLE
To disconnect the I/F cable at the scanner, insert a bent paper clip or
.050" hex driver into the opening marked CABLE RELEASE as shown in
Figure 1, and push inward. Once the connector latch is released, con-
tinue to hold in on the latch while carefully pulling the cable free.
Connect the scanner to your system using ONLY the proper PSC ap-
proved QuickScan 6000/6000 Plus I/F cable.
WARNING
Connection using an unapproved cable can result in damage
to the scanner. QuickScan 6000/6000 Plus cables can be
identified by a cable I.D. code printed on a white label, ap-
proximately 1" in length, attached to them.
Interface
Connector
Overmolding
Latch
Approved
QuickScan 6000/6000+ Cable
DO NOT use
unapproved
cables
Paper Clip
Cable Release
Figure 1. Disconnecting/Connecting the QuickScan 6000/6000 Plus I/F Cable
1
R44-1549
