PSC Scanning Imager 8000, Руководство по программированию и просмотру на экране

Страница: 17 / 88

R44-2080
11
Communications
Use the Communications pull-down menu (see Figure 6) to configure
serial communication with your Reader in the following ways:
Always Send Wakeup Character – When this option is
chosen, a wakeup character command is sent to the
Reader prior to sending any command. This action
brings the Reader out of a low-power state. To cancel this
setting, click on the menu choice again.
Figure 6. Communications Menu
COM Port Setup – Use for configuring baud rate, number of
start, stop, parity bits, and the RTS level for the selected
COM Port. You can also switch between COM Ports one
through four. Changing these settings affects only the
computer on which OSPV is running; the Imager 8000 2D
Reader configuration does not change. If you select Can-
cel, your changes will be canceled. If you select OK, your
changes will go into effect.