PS Engineering
PMA450C Audio Selector Panel and Intercom System
Installation and Operator’s Manual
200-450-0800
Page 2-4
July 2022
2.4.3
Power
The PMA450C is compatible with both 14- and 28-Volt DC systems. A five (5) Amp circuit breaker is
required for all installations. Power and ground wires should be #22AWG connect power to J2 Pins 8 and 9.
Connect airframe ground to J2 Pin 10 and 11 only.
2.4.4
Communications Push-to-Talk
An important part of the installation is the PTT (Push-To-Talk) switches that allow the use of your aircraft
communications radio for transmissions. Only the person who presses their PTT switch will be heard over
the radio. If the pilot and copilot both use the PTT, the only pilot position has access to the radio. The pilot
position will have PTT control regardless of the mic selector switch or copilot PTT when the PMA450C is
in the
OFF
/E
MG
mode.
2.4.5
Audio Panel interface
The PMA450C is designed to interface with standard aircraft avionics, and presents a 510
receiver imped-
ance. For best results, a twisted-shielded cable is recommended from the avionics audio source to the audio
panel, with the shield grounded at the audio panel end.
Some avionics do not provide a separate audio low, and may introduce additional electrical noise into the
system. For best results, connect the audio low from the audio panel to the radio ground, using one conductor
of the twisted-shielded cable.
2.4.5.1
Speaker Load
The PMA450C contains a speaker amplifier. The PMA450C
does not
contain any resistive speaker loads.
Some older aviation radios units with internal speaker amplifiers, require a resistive load if their speaker
amplifier is not used. If needed, connect the radio speaker output from the transceiver to a 16
, 3W resistor
in the harness.
2.4.5.2
Installation with Monaural Headsets
Not recommended, because the benefit of IntelliAudio is lost. However, if desired, the PMA450C can be
installed monaurally by using the LEFT audio connections only (left side contains Fail-Safe audio). Do NOT
short left and right together.
NOTE: Mono headsets that short the tip and ring (i.e. older models) may introduce audio distortion
when used. Modern, stereo headsets are recommended in all positions.
2.4.6
Transmit Interlock
Some communications transceivers use a transmit-interlock system. To utilize the Split Mode feature, this
function must be disabled. Consult the radio manufacturer's installation manual.
2.4.7
Backlighting
The PMA450C has an automatic dimming of the pushbutton annunciation LEDs and marker lamps controlled
by a photocell. Control of the unit nomenclature backlighting is through the aircraft avionics dimmer. For 14
V aircraft, connect J2 Pins 6 and 7 to the aircraft dimmer bus, and pin 5 to ground. For 28-volt systems,
connect pin 7 to the aircraft dimmer, and pins 5 and 6 to ground.
If an external dimmer control is
not
used, a constant back light illumination can be established for nighttime
viewing. Pin 6 or 7 (depending on system voltage) must be tied to power (J2, pin 8 or 9) for the back lighting
system to work. The photocell mounted in the unit face will automatically adjust the intensity of the push-
button annunciator LEDs.
2.4.8
Unswitched inputs
J1, pins 31 (Unsw 1), 44 (Unsw 2) 29 (Unsw 3) and J2 pin 15 (Unsw 4) are unswitched, unmuted (by trans-
mitter keying), inputs.
