Prusa Original Prusa i3 MK2.5, Руководство пользователя

Страница: 10 / 29

5.2 Loading one of the filaments using the LCD Menu
1. Go to ​ LCD Menu - Load filament - Load filament 1/2/3/4/5
2. The selector will move to the first position, the corresponding LED will start blinking
red
3. Insert the filament into the correct PTFE tube and push it until it’s caught by the drive
gear
4. The filament will be pushed until it’s detected by the FINDA, then it will be retracted
from the selector, ready to be extruded when needed
5. The LED will turn green
5.3 Loading one of the filaments using the MMU control buttons
1. Using the left and right control buttons, move the selector to the position
corresponding with the filament number you’d like to load.
2. Insert the filament inside the white PTFE tube and continue pushing it until it’s not
possible to push it any further.
3. Press and hold the middle control button for a few seconds ​ .
4. The corresponding LED indicator will start
​
blinking red
​
.
5. Push the filament a little bit further into the white PTFE tube until it’s caught by the
extruder.
6. The LED indicator should turn green after a short while, signaling successful filament
load.
To
​ unload ​ filament simply pull the filament string from the white PTFE tube manually.
Pict. 6 - Inside of the MMU2 unit with properly loaded filament
9