Prusa Research PRUSA CW1S, Руководство пользователя

Страница: 23 / 70

23
4.10. Removing the print
Safety instructions - wear gloves!
When handling resins, always wear protective gloves and always clean up any drops of
resin around the printer. In case the resin gets into contact with your skin, wash it off
immediately with water and soap. If you experience discomfort (such as itching) or the
resin gets in your eyes, seek out a doctor immediately.
After the printing process finishes, open the lid
and
place the black plastic tray on the printer
as depicted in the picture.
Use a
plastic spatula or paper towels to wipe
the top part of the print platform clean. Then,
unscrew the black knob at the top of the tower
to unlock the platform. Carefully slide the print
platform out, and turn it sideways, so the
remaining resin goes back to the tank/tray.
Use the bundled metal spatula to remove the print from the print platform. To prevent injuries, do
NOT use your fingernails to remove the prints since the plastic can easily get under your nails
and break off.
Removing a printed object with a metal spatula
Inspect the printed sample object. Check for any inaccuracies, missing parts, visible
layers/lines, dents, blobs, and other defects. If your print has visible defects, check the last
chapters of this handbook for print quality troubleshooting.
You should
clean the print platform thoroughly after every print - drops of liquid resin can
solidify in sunlight, which would make them difficult to remove. Clean the channel at the top of the
print platform thoroughly. Use isopropyl alcohol to clean the platform.