PRÜFTECHNIK OPTALIGN smart RS5 BT, Руководство пользователя

Страница: 134 / 194

OPTALIGN smart RS5 BT handbook
134
3. Mount the bracket assembly to the coupling face of the non-rotatable shaft. If
the coupling face has a raised rim, the precision machined spacers are used as
shown [
3
] in order to separate the bracket faceplate from the coupling face.
(Without the spacers, there would be no direct contact between the faceplate and the
coupling surface surrounding the bolt holes – exactly the location where the faceplate
and coupling are being joined.)
The center part of the coupling face must not be used as a reference surface.
7 .2 .2 Mounting the laser holder assembly on to the rail
1. Loosen the handwheel slightly, then slide the laser holder assembly down the
center groove of the rail, with the T-nut acting as a guide [
1
].
The coupling shown
opposite has a raised
face flange. The provided
spacers are used to create
a three-point plane to
ensure that the faceplate
and the coupling face,
which is the reference
surface are joined
together.
Reference surface
3
H
Note
1
RS5 laser holder