PRÜFTECHNIK OPTALIGN smart RS5 BT, Руководство пользователя

Страница: 102 / 194

OPTALIGN smart RS5 BT handbook
102
Once foot movements have been established, the results are interpreted and
translated into shim thicknesses to be placed under the feet. How straightforward
this is, depends on the type of soft foot present.
5.17 Checking and correcting soft foot conditions
The three main types are parallel soft foot, angular soft foot, and induced soft foot.
There are instances where the soft foot is a combination of two or more types.
Checking for soft foot is part of machine and job preparation.
The machine to be checked is assumed to have four feet which are bolted down
in an approximately square formation. If the machine has six feet, it is advisable
to leave the middle feet loose and treat the machine as a four-footed machine.
Soft foot is measured only on machine designated as movable.
1. Set up the system in the normal way as described in sections 5.3 – 5.4, then
switch the laser on. Adjust the beam onto center of the sensor dust cap.
2. Switch the RS5 BT sensor on then open its aperture by lifting and rotating the
sensor dust cap to its “open” position.
3. Switch the OPTALIGN smart computer on then enter machine dimensions.
4. Use the navigation keys to highlight machine whose feet are to be measured.
5. With the machine highlighted, press
q
. The context menu appears.
6. Use
f
/
g
to highlight the context menu item ‘Soft foot measurement’
then press
e
to confirm selection. The “Soft foot” screen may also be
accessed by using the navigation keys to highlight , then pressing
e
to
confirm selection.
H
Note
The soft foot icon may be
used to directly access the
soft foot measurement
screen.