Get started
When the iPro Toddler/Tilt Lift has not been used for an extended period of time, it needs to be initialised.
The pillars are provided with a PIEZO™ sensor. This ensures that the upward and downward
movement of the lift comes to an automatic halt once an obstructing object is detected.
The lift will automatically move in the opposite direction. The system also increases the
personal safety to some extent, but does comply not with legislation regarding personal
safety.
Initialising the lift
Initialisation of the height movement of the lift
-
Place the lift in the lowest position by pressing the down button of the handheld or foot control
panel.
-
Once in the lowest position, again press the down button and continue to hold the button until
the lift has moved automatically a further 3 mm and then withdrawn. This takes no longer than 5
seconds.
-
Release the down button only when the lift has come to a complete standstill.
-
If the down button is released before the lift has stopped, initialisation will be interrupted and the
process must be restarted.
-
The columns are now initialised and ready for use.
Initialisation of the tilt function
-
Place the screen in a horizontal position by pressing and holding down the tilt down button of the
manual control panel.
-
Once in the lowest position, again press the tilt down button and continue to hold the button until
the screen has moved automatically a further 3 mm and then withdrawn. This takes no longer than
5 seconds.
-
Release the tilt down button only when the lift has come to a complete standstill.
-
If the tilt down button is released before the screen has stopped, initialisation will be interrupted
and the process must be restarted.
-
The tilt function of the lift is now initialised and ready for use.
User manual
iPro Toddler/Tilt lift
10
