Protocol Propaq 242, Инструкция по применению

Страница: 90 / 120

90 Protocol Systems, Inc.
Install Printer Paper
Caution
Use only low-debris printer paper listed in the Protocol Systems Products and Accessories booklet. Use of
other paper can cause unclear printing of patient data, printhead damage, and eventual printer failure. Store all paper
(including a monitor loaded with paper) in compliance with paper storage specifications (see page 113).
1.
Lay the monitor on its back to gain access to the bottom of the printer.
2.
Squeeze the locks on the paper door and pull out to open it.
3.
Lift the paper roll from the holder and pull out any paper remaining in the printer.
4.
Place the new paper roll onto the spindle on the door as shown, and pull out several inches of
paper.
5.
Slide the end of the paper into the printer slot until it extends out the side.
6.
Close the paper door and turn the monitor upright.
7.
Simultaneously press the
START/STOP
and
PRINT
TRENDS
button. Confirm the monitor prints a test
print similar to the following: