Protocol Propaq 242, Инструкция по применению

Страница: 62 / 120

62 Protocol Systems, Inc.
Network Alert Message with Acuity
NETWORK FAULT, CHECK ACUITY/DATA COMM CONNECTION.
The Propaq CS monitor
detects a problem in communication with Acuity. Check the Acuity network cable to be sure it is
plugged in to the side panel and to the bedside jack. If the cable is damaged, replace the cable. If
the cable appears undamaged and the Acuity system is operating normally, ask your service
personnel to check the network and the Propaq CS monitor Acuity connector.
Program Alert Message
PROGRAM FAULT, SETTINGS LOST, TIME/DAY RESET. At powerup, the monitor cannot
recall the programmed Custom patient mode settings and current time and date. This can occur if
the battery is drained or after new software has been installed.
If this occurs, the monitor provides a special sequence of display windows to help you regain use
of your monitor as quickly as possible. Do the following:
1.
Connect an ac power adapter to recharge the battery (if the battery is drained).
2.
Press any key below the equipment alert screen to acknowledge the alert. The monitor
displays the Mode Setup window (shown on page 23).
3.
Press these keys to select one of the Factory patient modes for use:
•
Factory Adult mode:
POWERUP*, YES.
• Factory Pediatric mode:
NEXT, POWERUP*, YES.
• Factory Neonatal mode:
NEXT, NEXT, POWERUP*, YES.
After you press
YES
, the monitor displays the Time/Day window.
4.
Press
NEXT, UP,
and
DOWN
as needed to set the time and date. Then press
ENTER
to store the new
time and date.
5.
Turn off the monitor, then turn it on again so the settings will take effect.
The monitor is ready for use. To store customized patient mode settings, refer to page 24.
If you follow these steps and the equipment alert reappears at powerup, the monitor may need to be
serviced and the battery replaced. Contact a qualified service person.
Note
These display screens are only displayed in this order if the PROGRAM FAULT equipment alert occurs.