Protocol Propaq 242, Инструкция по применению

Страница: 39 / 120

Propaq CS Directions for Use 39
Monitoring
NIBP
INTERVAL
Selects the measurement interval for Automatic Mode NIBP measurements:
1, 2, 3, 5, 10, 15, 30, or 60 minutes.
For intervals 5, 10, 15, 30, or 60, measurements occur at corresponding intervals
past the hour. For example, if 5 is selected at 10:47:20, the measurements occur at
10:50, 10:55, 11:00, etc.
For intervals 1, 2, or 3 minutes, measurements begin 1, 2, or 3 minutes after the
interval is set. For example, if 1 is selected at 10:47:20, the next measurement
starts at 10:48:20.
TURBOCUF
Automatically starts NIBP measurements and takes as many as possible
within five minutes. To stop the Turbocuf Mode, press
STOP
or the
Start/Stop
NIBP
key.
After you stop the Turbocuf Mode or the monitor completes the five-minute
Turbocuf cycle, the monitor returns to the previous NIBP mode (Automatic or
Manual).
SMARTCUF
Enables or disables the Smartcuf motion artifact filter. NIBP measurements
can still be taken when Smartcuf is off. Artifact may interfere with the
accuracy of NIBP measurements with Smartcuf off.
6.
If motion artifact such as shivering, coughing, or other motion interferes with NIBP readings,
do the following:
Position the patient’s limb away from the body so the applied cuff is not in contact with the
patient’s body or any other object such as a bed rail. Try to keep the cuff at the same level as
the heart.
Make sure the Smartcuf filter is ON. Make sure ECG leads are properly connected to the
patient and perform ECG monitoring during NIBP. (ECG monitoring is required for
Smartcuf.)
7.
Set alarm limits according to your facility’s standards.