Polski Rejestr Statków S.A. al. gen. Józefa Hallera 126, 80-
416 Gdańsk, Poland
According to European standard EN365:2004 and EN795:2012 type B a requirement to check the legibility of the product
PROTEKT Grzegorz Łaszkiewicz ul.Starorudzka 9 93
-
403 Łódź
Use and instruction manual of connecting lanyard with fall indicator
AZ411
EN 795:2012 Type B
CEN/TS 16415:2013
If the device is used as a part of a fall arrest system, the user must be
equipped with an element limiting maximum dynamic forces applied on user
while arresting a fall to max. 6 kN.
The device cannot be installed so support line of the device touches a sharp
edge with radius of below 0.5mm.
TABLE OF CONTENTS:
1. General
1
2. Overall dimensions of connecting lanyard
2
3. Time of usage
2
4. Periodic inspections
2
5. Marking of device
3
6. Installation of anchor point
3
7. Installation of device
3
8. Essential principles of use of personal protective equipment against falls
from a height
3
9. Warranty
5
10. Identity card
5
1. General
Connecting lanyard AZ411 is an anchor device compliant with EN 795 Type B
and can be used to provide protection of 3 users at the same time.
Connecting lanyard AZ411 can be used only as personal protective
equipment to protect user against a fall from a height, and cannot be used
for lifting loads.
The device is composed of PVC-coated galvanized steel cable and aluminium
thimbles.
According to EN 795:2012 Type B static strength of this anchor point is min.
14kN towards direction of force, and in configurations as shown in Figure 1,
the device can be used by 3 users at the same time.
The maximum load that could be transmitted in service from the device to
the static construction - 10 kN. This is the actual force which the anchor
point transfers onto the structure to which it is attached when a fall occurs.
Figure 1. Acceptable methods of installation of device
