21
PRS-UM-PPSM-EN-Rev.03-10.04.2020
6.7 Scan Detectors:
In case any detectors added, replaced or changed on PPS Manager, Scanning should be initiate to
allow panel recognize the detectors. This can be done via eight item on the menu. Press menu
button and use up and down arrow buttons to reach “Scan Det“ menu item:
Press menu button again to start scanning. It will request confirmation again:
press menu button again to start scan operation.
It will take at least two minutes to complete scan operation. The screen will show number of
detectors when scan opration completed:
Press T button to return back to main menu. Menu will return to display mode if user not take any
action for a minute.
6.8 Show Detector:
Show detector menu item shows each detectors status in detail. Press menu button and use up and
down arrow buttons to reach last menu item “Show Det“ menu item:
Press menu button again to see detectors one by one. It will show detector number, measured gas
type and current gas measurement level on screen:
Scan Det
Start?
Detector
12
Show Det
Scanning
Detector
