Sport Bike Carrier
Installation Instructions
9.
1.
Remove the end caps from the crossbars.
Place the two wheel straps around the wheels and wheel tray and pull tight to secure.
Adjust the crossbars to a spacing no less then 24 inches apart.
Assemble a nylon washer onto each T-bolt before installing in the crossbar.
Insert one T-bolt with washer in the rear crossbar and two T-bolts with washers in the front crossbar.
Replace end caps.
ProRac Systems Inc.
Toll Free: 1-800-217-7133
7109 31
st
Avenue North
Phone: 763-546-5620
Minneapolis, MN 55427-2848
Fax: 763-546-0933
WWW.PRORAC.COM
2.
Assemble the wheel tray using the two nuts / bolts / washers provided.
PRO RAC GUIDELINES
Please review the instructions and warranty carefully. Assembly and installation are the purchaser’s responsibility and beyond ProRac’s control.
Therefore, ProRac exclusively limits its warranty to the repair or replacement of a defective ProRac product for up to three years from retail
purchase. Warranty excludes damage to your vehicle, cargo, or any person or property during assembly, installation, and use.
♦
Do not carry more than 150 pounds (68KG) of combined cargo and accessories on ProRac crossbars. ProRac crossbars do not increase gutter
or roof strength. ProRac cannot warranty loads that exceed this limit.
♦
Do not use ProRac crossbars and accessories for purposes other than those for which they were designed. Do not exceed their carrying
capacity. Failure to follow these guidelines or the product instructions will void the warranty.
♦
Make sure all knobs, bolts, screws, straps, and locks are firmly attached, tightened, and locked before every trip. All fasteners must be
periodically inspected for signs of wear, corrosion, and fatigue. Check your load at stops during long trips to ensure continued fastening
security.
♦
Check all local and state laws governing projection of objects beyond the width and length of vehicle. Be aware of the width and height of your
cargo since low-clearance branches, bridges, and parking garages can affect the load. Never drive with any lock, knob, or rack in an open or
unlocked position. All long loads such as, but not limited to, sailboards, surfboards, kayaks, canoes, and lumber must be tied down front and
rear to the bumpers or tow hooks of the vehicle.
♦
Remove your rack and accessories when they are not in use and before entering automatic car washes.
♦
All locks must be turned and moved periodically to ensure smooth operation. Use graphite or similar dry lubricant. Locks are designed to deter
vandalism and theft. Remove valuable gear if your vehicle is unattended. Replacement keys are available only through your ProRac dealer.
♦
All cargo will affect the vehicle’s driving behavior. For your safety, adapt your speed to the conditions of the road and load being carried. Obey
all posted speed limits and traffic cautions.
♦
Due to their wind resistance, do not carry disks or wheels with covers on the ProRac bike carrier.
Consult your ProRac dealer if you have questions regarding the operation and limits of ProRac pr
♦
information carefully.
oducts. Review all instructions and warranty
FGAT1599-IS
©
2006
ProRac
Systems,
Inc.
Revised
6-27-06
