________________________________________________________________________________
11
–
Lift trolley Lift&Drive
70IE / 90IE / 90JE
5.2.8
Knobs for handlebar and bracket for remote control
Check that the knobs loosen and tighten correctly.
5.2.9
Replacing the fuse
The fuse is located inside the power pack. A wiring diagram for the lift trolley is attached to the
inside of the lid of the power pack. Before removing the lid, by loosening the screws, the user
should apply the brakes and wear protective footwear. Be extra cautious when opening the power
pack. If the device is tilted after the lid has been removed, the batteries can slide out of the power
pack and harm the user.
5.2.10
Replacing the batteries
Batteries may be replaced by a person with basic technical knowledge. When changing batteries
protective footwear should be used the brakes should be applied. To open the power pack, see
section
Replacing the fuse
. Used batteries should be handed in to a recycling centre.
5.2.11
Plates and decals
Verify that the following plates and decals are attached and fully readable.
Plate/decal
Description
Placement
CE Decal
Decal with CE mark and year
of manufacture
At the back of the cross-
member
Serial number
Decal with serial number
At the back of the cross-
member
Model
Decal with text stating the
model of the lift trolley
At the top on both the left and
the right side of the column
Maximum load
Decal with text stating the
maximum load and that
lifting people is not allowed
Clearly visible on the power
pack
No feet
Striped decal with an image
to warn against placing feet
on the wheel frame
On the wheel frame
(2 pcs)
Not for lifting people
Decal with image showing
that lifting people is not
allowed
On the cross-member
(2 pcs)
Safety information
Decal with text informing
about safety and contact
information
Clearly visible on the power
pack
