g
IgabIt
p
ort
leD
s
Check the network connection on the rear panel to make sure the system is accessible for configuration. The
Gigabit Ethernet ports have Link/Act and Speed LEDs located above each of the two ports.
The LED on the right side above each port lights when connected, flashes when there is activity on the port and
remains dark no connection has been established.
F
ront
P
anel
led
S
When boot-up is finished and the Vess A3340 system is functioning normally:
LED
Description
Power
Lights BLUE to indicate the system is powered on.
System Status
Lights GREEN when healthy, RED if there is a critical problem (LD offline, fan malfunction,
voltage out of range, system temperature alert), blinks RED for HDD high temperature alert
remains dark when not ready.
Global RAID Status
Lights GREEN when healthy or RED if any RAID volume is offline, ORANGE for critical state
of any logical drive.
Global HDD Activity
Blinks BLUE to indicate one or more drives are being accessed, remains dark when no
drives are being accessed.
HDD Status
One LED for each HDD carrier. Each LED lights GREEN when healthy, RED if the RAID
member is offline or there is a physical disk error, ORANGE indicates the drive is rebuilding,
and a dark LED indicates either no drive is installed or the drive is not configured.
Fan Status
Lights GREEN when healthy, RED indicates a fan in the System module is not operating in
normal range, ORANGE indicates the CPU fan module is not present.
Network
One LED for each LAN port. Lights BLUE to indicate a valid link, blinks BLUE to indicate
activity on the port.
OPAS USB
Lights GREEN if an OPAS device (USB disk) is detected, RED if the OPAS operation has
failed, blinks GREEN when an OPAS operation is in progress.
Recording
RED indicates application running.
25
Hardware Setup
Vess A3340 Product Manual