CAUTION!
Danger from rupturing hydraulic components
Peak loads during the dosing stroke can cause the
maximum permissible operating pressure of the
system and pump to be exceeded.
– The discharge lines are to be properly
designed.
CAUTION!
Danger of personnel injury and material damage
The use of untested third party parts can result in
personnel injuries and material damage.
– Only fit parts to metering pumps, which have
been tested and recommended by ProMinent.
8.1 Installing hose lines
8.1.1 Installation with metering pumps without degassing
CAUTION!
Warning of feed chemical spraying around
The pipes can become loose or rupture if they are
not installed correctly.
– Route all hose lines so they are free from
mechanical stresses and kinks.
– Only use original hoses with the specified hose
dimensions and wall thicknesses.
– Only use clamp rings and hose sleeves
intended for the respective hose diameter to
ensure the long service life of the connections.
CAUTION!
Danger from rupturing hydraulic components
Hydraulic components can rupture if the maximum
permissible operating pressure of the hydraulic
parts is exceeded.
– Always adhere to the maximum permissible
operating pressure of all hydraulic components
- please refer to the product-specific operating
instructions and system documentation.
– Never allow the metering pump to run against
a closed shut-off device.
– Install a relief valve.
Safety information
Installation, hydraulic
23
