INSTALLATION GUIDE
For
ACTIVote UPGRADE KIT for the ACTIVboard
PROMETHEAN LTD
TP
1397
Issue 1
TP1397 PRM-AVOTE-UPGRADE Installation instructions
2
ACTIVote Upgrade Kit.
Installation instructions.
Installing the hardware.
The ACTIVote transceiver is installed by simply plugging the 25 pin
connector into the slot provided on the upper surface of the ACTIVboard
electronics pod. This is behind the upper left corner of the board.
Two alternatives for housing the transceiver are illustrated below:
Installing the software.
You will need the diskette provided with the upgrade kit. Follow the
instructions (either A or B depending on your PC set up), below to flash
upgrade your ACTIVboard Plus system to ACTIVote:
REAR VIEW
