7
Installation
All ProTournament Battery Chargers are designed to be permanently mounted
on-board, and can be mounted at any angle.
Do NOT mix battery types on-board. All batteries should be of the same age
and in good operating condition.
Do NOT make any electrical connections to the ProTournament or batteries
until the following steps are completed:
11 Easy to follow installation steps:
1
. Select a mounting location that allows for ventilation any time the charger is used.
Open all battery and engine compartments and ventilate for at least 15 minutes before
starting the installation of the ProTournament charger.
2
. Make sure the selected mounting location allows for a minimum of 6 inches of free
space around front and sides of the ProTournament charger. Be sure to place the
ProTournament in an accessible area where all indicators are viewable. Confirm all
battery cables can reach each of the batteries.
3
. Using the ProTournament as a template use a small awl or screwdriver to mark the
position of each mounting hole.
4
. Using a 1/8" drill bit, drill pilot holes in the (4) marked locations as described in step 3.
Apply a silicon sealer in each of the mounting locations to waterproof the screw holes.
5
. Position the ProTournament over the mounting holes and using a power screwdriver
install the (4) stainless screws provided.
I n s t a l l a t i o n G u i d e l i n e s
1/8" pilot hole
with silicon sealer
IMPORTANT NOTICE
Confirm the surface you will
be mounting the charger to
is adequate in strength
and thickness to hold the
ProTournament in place with
stainless steel screws provided.
stainless steel
screws provided
