ProLights H150UFC, Руководство пользователя

Страница: 27 / 44

7
H150UFC
so after being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down for a
short period in order to heat up again. During this time no fog can be produced.
2.3 OPERATION
Connect the supplied main cable to a socket (100-240V~/50-60Hz). Then the unit is ready for operation
and can be operated manualy, via a DMX controller, via timer function or via the supplied wireless remote
control.
To emit smoke with the machine, refer to the following guide:
1. Add fluid carefully to the liquid tank. Do not overfill the tank.
2. Plug power cord into a grounded electrical outlet. The unit will start to warm-up the machine. Wait
a few minutes for heating element to heat up (5 min. approx.). During this time the machine cannot
generate any fog. When the warm-up process is complete the display will show “Ready to Fog”. So the
unit is ready for use.
3. To begin to emit smoke in manual mode, press the
Volume
button located on the control panel.
4. To end the emission of smoke, press the STOP button located on the control panel.
5. Please now refer below of instructions of Remote Controller for setting for the remote controller com-
mand.
Important:
• Always monitor tank fluid level as you are fogging.
• Never drink Fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin
or eyes, rinse thoroughly with water.
• Always replace the caps on the fog liquid container immediately after filling to avoid contamination.
NOTE - If you experience low output, pump noise or no output at all, unplug immediately. Check fluid
level, the external fuse, and power from the wall. If all of the above appears to be O.K., plug the unit again.
If fog does not come out after holding the control panel button down for 30 seconds, check the hose at-
tached to the tank to make sure there is fluid going through the hose.
If you are unable to determine the cause of the problem, do not simply continue pushing the remote but-
ton, as this may damage the unit. Return the machine to your dealer.
To switch off, disconnect the mains plug from the socket. For a more convenient operation it is recom-
mended to connect the unit to a socket which can be switched on and off via a light switch.
2.4 WIRELESS REMOTE CONTROL
The wireless remote control system consists of a transmitter (fig.3) equipped with four buttons for fog
output on and off, and a receiver (fig.4) pre-attached to the rear panel of the unit.
Transmitter
With the wireless transmitter (fig.3) it is possible to emit fog via radio over a distance of up to 50 meters.
Receiver
The wireless receiver (fig.4) is tested and pre-attached to the rear panel of the H150UFC. Please do not try
to remove it. The receiver responds to up to 10 different transmitters that are registered with the machine.
The included transmitter has been registered with the machine before shipment. It can be directly oper-
ated without any start-up setting.