Cleaning the hob
•
Remove immediately:
melted plastic,
plastic foil, sugar and food with sugar. If
not, the dirt can cause damage to the
hob. Take care to avoid burns. Put the
special scraper on the glass surface at
an acute angle and move the blade on
the surface.
•
Remove when the hob is sufficiently
cool:
limescale rings, water rings, fat
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
•
Remove shiny metallic discoloration:
use a solution of water with vinegar and
clean the glass surface with a moist
cloth.
TROUBLESHOOTING
WARNING!
Refer to Safety
chapters.
What to do if...
Problem
Possible cause
Remedy
You cannot activate or oper-
ate the hob.
The hob is not connected to
an electrical supply or it is
connected incorrectly.
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec-
tion diagram.
The fuse is blown.
Make sure that the fuse is the
cause of the malfunction. If
the fuse is blown again and
again, contact a qualified
electrician.
Activate the hob again and
set the heat setting in less
than 10 seconds.
You touched 2 or more sen-
sor fields at the same time.
Touch only one sensor field.
STOP+GO function operates.
Refer to "Daily use" chapter.
There is water or fat stains on
the control panel.
Clean the control panel.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
You put something on one or
more sensor fields.
Remove the object from the
sensor fields.
The hob deactivates.
You put something on the
sensor field
.
Remove the object from the
sensor field.
Progress
31
Содержание PAI3100F
Страница 77: ...Progress 77...
Страница 78: ...78 Progress...
Страница 79: ...Progress 79...
Страница 80: ...www progress hausgeraete de 867332060 A 412016...